Configuring a Branch

First published on: 08/08/2023/10:38 pm

Each branch type has different configuration settings. The setup for each branch type is outlined below.  

All branch types require the same basic settings: 

• ID – Unique branch identifier. You can customize the auto-generated ID, but it must be unique before you can save the workflow. 

• Description – Admin-facing branch name that's used in troubleshooting.  

• Branch type – This specifies which branch type the current branch is. Changing the branch type will remove previous configurations. 

• Enable branch – When checked, the branch will be executed by the workflow; otherwise, it will be ignored. 

• Message to use – The branch that will be inspected for advanced settings. This is specified for all branches but not applicable in all cases.  

• Exception handling mode – You can configure the exception handling mode for a branch, as outlined in Optionally Configure Exception Handling. 

See the following sections:

Configure a For-Each Loop Branch 

Configure an If or If-Else Branch

Configuring a Simple Branch

Configure a Switch Branch

Previous

Next